To maintain a jetted tub, we recommend cleaning the jets twice a month to reduce any trapped air in the jets. You can use a homemade bathtub jet cleaner to deep clean the tub and keep the jets running properly. Explore this blog to learn how and when to clean your jetted tub.

You can expect to hear some noise when you run the bathtub jets. Since jets run from an engine, you might hear the engine crank when the jets start up. Many jetted tubs, including the KOHLER® walk-in bath, complete an automatic water purge about thirty minutes after you turn off the bath. 

 

This purge takes approximately one minute. If you think any noise coming from your jets is abnormal, contact your installer or manufacturer.

For the best results, clean your whirlpool jets at least twice a month. If you use your walk-in bath more than 3 times per week, we recommend cleaning the whirlpool jets at least twice a month.

 

To keep your bath jets clean, avoid using any bath bombs, oils, or bubble baths in the tub. These products can build up within the jets, leading them to release black flecks.

We have found that one of the best jetted tub cleaners is actually homemade. Combine the following ingredients: 

• Low-foam, powder dish detergent (2 tsp.)

• Household bleach (20 oz.)

Follow these steps to clean your bathtub jets:
 

• Step 1 - Adjust the Jets Clockwise: First, rotate the jets clockwise to remove all air induction. This step helps reverse the jet function, so they don’t run while you clean them. 
  
  
• Step 2 - Fill Bathtub with Warm Water: Fill your bathtub with warm water until it is at least 2 inches above the jets. To achieve the full cleaning effect, use warm water when working with the cleaning solution.
  
  
• Step 3 - Add a Cleaning Solution: Once the water passes the jets’ height, add the cleaning solution to the water. Let the solution soak for a few minutes. 
  
  
• Step 4 - Run Whirlpool: Run the jets like you would if you were taking a bath. This helps the cleaning solution circulate.
  
  
• Step 5 - Stop Whirlpool: After running the jets for 5-10 minutes, stop the whirlpool.
  
  
• Step 6 - Drain Water: Now, your jets are clean and ready for use. Add this to your weekly cleaning routine for the best results for your walk-in tub.

Have more questions about cleaning, maintaining, or getting the most from your walk-in bath? Our blog is packed with helpful resources, step-by-step guides, self-care tips, and expert advice to keep your bath sparkling, and enjoyable for years to come. Explore our posts to learn how to care for your KOHLER walk-in bath and elevate your daily bathing experience.